Peptides and human growth steroid Oxytocin Acetate,Pharmaceutical Intermediates,Ibutamoren Mesylate Qidi Chemical Co., Ltd. , http://www.czchemicals.com
Multi-purpose thresher installation and use
1. The thresher should be mounted on a thick and consistent wooden frame and securely fastened with screws. The push button switch should be safe and protected against electric shock when it is convenient for operation; with the diesel engine as power, the diesel engine should also be fixed firmly so that the center distance of the two pulleys is kept at a distance of 1.5-2 meters. The opening of the thresher should be approximately the same as the natural wind direction. If a diesel engine is used as a power source, the installation of the diesel engine should be contrary to the exit of the straw. Before the feeding stage, square tables or plankings, which are the same as the feeding stage, should be placed so as to stack the fed crops. 2. Use the appropriate pulley according to the instruction manual. If dry wheat is used, the outer diameter of the motor pulley is 120 mm, and the outer diameter of the roller pulley is 135 mm. Before starting the machine, the bearing should be added with butter, check the inside of the machine for debris, and tighten the connecting bolts. Pull the pulley to hear if there is friction noise. If it should be overhauled, then drive and test it. 3. The amount of feed should be increased or decreased according to the dry and wet conditions of the crop and the length of the stem. If it is found that the broken rate is high, the gap between the roller and the concave plate should be increased, and the roller pulley should be replaced. The crops should be fed one after the other. If a twisting rope occurs, stop the feed immediately and feed it after the gallows disappear. If a blockage occurs, stop it immediately to eliminate it. 4. It is forbidden to feed hard objects such as metal, tools, wooden blocks, stones, etc. into the machine to avoid damage to the machine and injury; after each operation, it is necessary to idle for a few minutes before stopping. When used as a weed, remove the top cover, pull out the two hanging plates of the concave plate, pull one end of the concave plate out of the box about 50 mm, and press the hole to install the file, the direction of the knife edge should be the same, and then put it. Then pull the indentation plate out of the box 50 mm from the other direction, install the sacral knife in the same way and put it back in place. Finally, install the boom and cover.