JRT has been R&D Laser Distance Sensor every year. In this part, we put every new sensor here. To help our customer to find the lastest item. To know the updates we are doing, what's new for laser distance modules. What kind of Laser Distance Meter sensor we can make. New Laser Distance Sensor,New Laser Distance Module,New Distance Sensor,New Laser Sensor Chengdu JRT Meter Technology Co., Ltd , https://www.cdlaserdistancemeter.com
Let's explain the correct operation of the shredder:
1. The long-term operation of the pulverizer should be fixed on the cement foundation. If the working place is changed frequently, the pulverizer and the motor should be installed on the base made of angle iron. If the pulverizer is powered by diesel, the power of the two should be matched, that is, the power of the diesel engine is slightly larger than the power of the pulverizer, and both The pulley grooves are the same, and the outer end faces of the pulleys are on the same plane.
2. After the pulverizer is installed, check the fastening condition of each fastener. If it is loose, tighten it.
3. Check that the belt tightness is appropriate and that the motor shaft and the shredder shaft are parallel.
4. Before starting the pulverizer, first turn the rotor by hand to check whether the teeth, hammer and rotor are running flexibly and reliably. There is no collision in the shell. The rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine. Motor and powder Whether the machine lubrication is good.
5. Do not change the pulleys casually, in case the rotation speed is too high, the explosion chamber will explode, or the rotation speed is too low, which will affect the working efficiency.
6. After the pulverizing table is started, it will be idling for 2 to 3 minutes. After no abnormal phenomenon, it will be fed again.
7. Keep an eye on the operation of the crusher at work, and feed it evenly to prevent blockage of the car and do not overload it for a long time. If vibration, noise, high temperature of the bearing and the body, and external spraying are found, stop the test immediately and continue working after troubleshooting.
8. The crushed materials should be carefully inspected to prevent accidents such as copper, iron, stones and other hard objects entering the crushing room.
9. Do not wear gloves when handling the staff. When feeding, stand on the side of the crusher to prevent rebound debris from injuring the face.
Through the above simple description, the pulverizer can be operated according to these specifications, so that the pulverizer can be operated normally, and accidents can be avoided as much as possible.
Best Regards
JRT Team
Introduction to the correct operation of the shredder
The pulverizer is a machine that pulverizes a large-sized solid raw material to a desired size. The use of wind energy to powder at one time eliminates the traditional screening process. During the operation of the pulverizer, correct operation is required to make it operate normally and avoid malfunction.